Yes. A home in Maple Shade, in Burlington County, needs its chimney looked over and signed off before a sale closes or a new tenant moves in, assuming the house has a fireplace or any other chimney attached to it. Maple Shade requires a certificate of occupancy inspection ahead of a sale, and the township's housing inspection checklist carries its own line for the chimney, separate from the furnace, the water heater and the rest of the mechanical rundown. Renter-occupied housing is common in Maple Shade, so that same checklist line comes up again whenever a unit changes hands between tenants, not only at closing.
What the checklist asks for
The housing inspection checklist calls for every fireplace and any chimney attached to the house to be signed off by a qualified contractor holding a valid license, with that contractor's signature and the date on the form. The inspector is not the one climbing onto the roof or dropping a camera down the flue. The form asks a licensed contractor to do that part of the look and put a name and date to what was found, and the inspector checks that the paperwork is filled out and current before the certificate moves forward. The checklist also spells out what the chimney itself has to show: masonry that is pointed or covered, a cap in place, no lean to the structure, and the heating vent stack sealed where it enters the chimney rather than left open or loosely fitted. A contractor doing this work signs that inspection form to show what was found and repaired. The certificate of occupancy itself still comes from the township once its own inspector reviews everything on the form.
What a technician checks before putting a name to it
Signing a form that says a chimney passed means going through the whole system, not glancing at the stack from the driveway. Chimney Cleaning comes first on most of these calls, since a flue packed with old creosote or blocked by a bird's nest hides problems that only show up once the flue is swept down to bare masonry. Behind that sweep is where the real inspection happens. The crown at the top of the chimney gets checked for cracks that let water into the masonry below it. The cap gets checked for rust or a loose fit that lets rain or wildlife inside. The mortar joints above the roofline get checked for the gaps and missing mortar that let water travel down through the brick over years of freeze and thaw. Any lean to the chimney gets noted as well, since a stack that has shifted off plumb usually points to a foundation or flashing problem that goes past the chimney itself. The seal where the furnace or water heater vent connector enters the chimney gets a look too, since a loose or rusted-through connection there lets combustion byproducts leak into the house rather than up the flue where they belong.
Repairs that come before the sign-off, not after
A chimney that shows a cracked crown, a missing cap, open mortar joints or a loose vent connector does not get signed off with a note to fix it later. Those repairs happen first, and the sign-off follows once the work is done and the chimney has been looked at again to confirm the fix held. Chimney Repair covers this range of work: crown and crack repair, cap installation, smoke chamber repair, damper repair, flue repair and relining, and a full rebuild where the masonry has gone past the point a repair can hold. Which of those a given chimney needs depends on what the inspection behind the sweep turns up, and a written estimate lays out the scope once that inspection is finished rather than guessing at it beforehand.
Timing against a closing date or a move-in date
A chimney inspection and any repair it turns up takes real time to schedule and finish, and leaving it for the week before closing or the day before a new tenant's lease starts puts the whole timeline at risk. Masonry repair, a crown rebuild or a stretch of repointing above the roofline, is not a quick fix if weather does not cooperate or if the mortar needs time to cure before anyone can call the job finished. Booking the inspection as soon as a sale is under contract or a lease is signed, rather than waiting for a closing date to get close, leaves room for a second look and a repair in between if the first visit finds something that the checklist will not pass as it stands.
Items the township can flag even off its own list
Maple Shade's own housing checklist notes that a home can still be cited for conditions the inspector finds even when the specific item is not spelled out on the printed form. A chimney can pass every listed item, pointed masonry, a cap, no lean, a sealed vent connection, and still get flagged for something else the inspector sees on the day: a chimney crowded by a tree limb, a flue cap blocked by debris, or water staining inside the attic near the chimney chase. That is part of why the inspection behind the sweep matters as much as the checklist items themselves. A technician who only checks the four listed conditions and skips everything else leaves the seller or the landlord exposed to a citation the printed form never mentioned.
